Plant Design Basis and Conditions :
- We have designed this system to produce permeate flow 500 Liters per hour.
- Maximum TDS Level of Raw Water (input) upto 2500 ppm.
- The treated water quality as required i.e pH 7-8 after correction ,TDS <100 PPM & Hardness < 50 PPM can be achieve , subject to the feed water quality is the same as specified above .In case of any change in the quality of raw water it may have implication on operating parameters or on end results of the system.
- The system of recovery is properly maintained corresponding to the raw water TDS.
- RO feed water limiting conditions as mentioned below are strictly maintained,
X Cube 500LPH RO Plant
Parameter Results Turbidity < 1 NTU Free Chloride Nil Oil & Grease Nil Iron <0.1 PPM SDI <4.0 Temperature < 45 degree C 500 LPH RO SYSTEM
SCOPE OF SUPPLY
No. Description Quantity
- Raw Water Feed Pump with motor 1 no.
- Sand Media filter 1 no.
- Activate Carbon filter 1 no.
- Anti scalent Dosing pump 1 no.
- Housing with filter 5 micron 2 nos.
- SS Multistage high pressures pump 1 no.
- Membrane Housing 4080 E2 FRP 1 no.
- R O Membrane High rejection ( 99.3%)Brackish 2 nos.
- Water 4040
- Multi Port Valves 3/4” in & out Imp 2 nos.
- Fine filtered water-blending line with micron
- Filter, PVC pipe line and fittings 1 lot.
- MS electrical panel with controls 1 no.
- Pressures Gauges 3 nos.
- Rota meter reject & permeate 2 nos.
- SS Skid 1 no.
-
TECHNICAL DETAILS
Row water feed pump
Type : Monoblock Centrifugal
Material of Construction : C.I
Make : CRI , Kirloskar
Drive motor : SinglePhase
Sand Media Filter
Working : Down flow
Max flow rate : 3m3/hr
Min. flow rate : 0.5 m3/hr
Working pressure : 1.5 – 3.5 kg/cm2
Size : 10”X54”
Make : Pentair
Valves : Multiport valve 25mm
Carbon Filter
Working : Down flow
Max flow rate : 3m3/hr
Min.flow rate : 0.5m3/hr
Working pressure : 1.5 – 3.5 kg/cm2
Size : 10”X54”
Make : Pentair
Valves : Multiport valves 25mm
Anti Scalant Dosing Unit
Make : IMP
Capacity : 6 LPH @ 3.5 bar
MICRON CARTRIDGE FILTER
Quantity : 1 sat
Flow rate : 3m3/hr
Rating : 10 micron
Make : Filtech / USF
CARTRIDGE HOUSING
Quantity : 2 nos.
Make : Polycarbonate
High Pressure Pump
Type : Multistage Centrifugal
Make : CRI/shakti
Drive motor : Single Phase
Model : CDL- 2-18
Membrane Housing Type : FPR
PSI : 250
Make : ALFA, Imp
Size : 4080 E2
MEMBRANE
Type : High Rejection Brackish water
Membrane : CSM /hi-tech/Vontron
Modal : 4040
Size : 40” x 40”
Rejection : 99.3% Max.
FLOW METER
Quantity : 2 nos.
Type : Glass Tube Rota mater
Make : Flow max, IMP
250 LPH RO Design Basis of R O System
- Plant Capacity :
- The Reverse Osmosis Plant has been designed to produce the desired output of 250 Liters per Hour.
- Raw Water analysis :
- The Reverse Osmosis System is designed on following raw water analysis as indicated below ;
Parameter Results Raw water source Bore Well pH Not Known TDS Upto 2500 Mg/L S.Solids Not Known Chlorides Not Known Fluoride Not Known Total Hardness Not Known Calcium Not Known Mg Not Known Total alkalinity as CaCo3 Not Known Silica as Si O2 Not Known Sulphate as SO4 Not Known - Plant Design Basis and Conditions :
- We have designed this system to produce permeate flow 250 Liters per hour.
- The treated water quality as required i.e pH 7-8 after correction ,TDS <100 PPM & Hardness < 50 PPM can be achieve , subject to the feed water quality is the same as specified above .In case of any change in the quality of raw water it may have implication on operating parameters or on end results of the system.
- The system of recovery is properly maintained corresponding to the raw water TDS.
- RO feed water limiting conditions as mentioned below are strictly maintained,
Parameter Results Turbidity < 1 NTU Free Chloride Nil Oil & Grease Nil Iron <0.1 PPM SDI <4.0 Temperature < 45 degree C SCOPE OF SUPPLY
S.No Description Make Qty Remaks 1 Raw Water Pump Kirloskar 1 No Capacity 1 m3 2 Sand Filter Aventura or Pentair 1 No H 1200 MM & Dia 250 MM Flow Rate 1500 Liter per hour 3 Carbon Filter Aventura or Pentair 1 No H 1200 MM & Dia 250 MM Flow Rate 1500 Liter per hour 4 Anti-scalent Dosing System E doze 1 Set Capacity 0-06 LPH 5 Micon Filter Hsg 20” Big Blue Imported 2 Nos 20” Big Blue with 4” Dia 6 Micron Filter 2 Nos 20” * 2” Dia 7 High Pressure Pump Sumo/ Nangfang/CRI 1 No Capacity 1 M3 8 Membrane Film Tech/ Hydronautics / Torrey 1 No Size 4” * 40” 9 Membrane Hsg Water Life 1 No 1 Elements in Hsg 10 C I P System Sharp/KBL 1 Set Optional at extra cost 11 Electric Control Panel LED Base 1 Set 12 Flow Meters Flow Star/ UKL 2 Nos 13 Pressure Switches Denfoss Or Equ. 2 Nos Low & High Pressure 14 Pressure Gauges H Guru 2 Nos 15 Pipe Fittings 1 Lot Upvc all over 16 R O Skit 1 No MS fabricated with epoxy paint or SS 202 17 Online Conductivity Meter Aster 1 No For Measuring On line Conductivity Optional at extra cost TECHNICAL SPECIFICATIONS Flow Rate Treated Water : 250 LPH based on TDS level upto 2500 PPM
- Raw Water Pump
Specifications
- Horizontal Centrifugal
- Power Required : 0.5 HP
- Make : Kirloskar & Eqv.
- Quantity : 1 No
- MEDIA FILTER
Specifications
- Make : Pentair / Aventura
- Material of Construction : FRP
- Dia & Length : 10*54
- Testing Pressure :6 Kg/cm2
- Opening : Top
- Quantity : 1 No
- Valve : Multiport Type Lever Type
- Size : ¾ Inch
- Maximum Flow : 2000 LPH
- Media : Gravel, Pebbles ,Quartz Sand ,Anthracite etc.
- CARBON FILTER
Specifications
- Make : Pentair / Aventura
- Material of Construction : FRP 10*54
- Testing Pressure :6 Kg/cm2
- Opening : Top
- Quantity : 1 No
- Valve : Multiport type, Lever tpye
- Size : ¾ Inch
- Maximum Flow : 2000 LPH
- Carbon : Acid wash with 1100 + ID valve
- MICRON FILTER
Specifications Cartridge Filter & Housing Big Blue Housing :
- Make : Imported in PP
- Length & Diameter : 20”*4”
- Quantity : 2 Nos
Cartridge :
- Make Ametek USA in PP
- Length : 20”
- Micron Rating : 05 Micron
- Quantity : 2 Nos
- DOSING SYSTEM
Specifications
- MOC: PP
- Capacity : 06 LPH
- Pressure : 10 psig
- Qty : 1 No
Ø Make : E Doze
- HIGH PRESSURE PUMP
Specifications
- MOC : Stainless Steel
- Type : Vertical
- Flow Rate : 1 M3
- Power Required : 1 Phase ,1.1 Kw
- Make : Sumo/CRI/Nangfang
- RO MEMBRANE
Specifications
- Type : Spiral Wounded
- & Length : 40*40
- No membrane : 1 No
- Recovery : Approx 30 %
- Make of membrane : Dow/ Hydranautics
- Salt rejection : 95-98 %
- RO PRESSURE TUBE
Specifications
- MOC : FRP Composite
- Pressure Vessels : 1 No
- No of membrane per vessel : 1 No
- Make : Water Life
- C I P SYSTEM ( Optional at Extra cost )
Specification
- With R W Pump & FRP Tank : 1 No , 100 Liter
- ELECTRICAL PANAL
Specifications
- Complete starters, overload relays , single phase prevention for pump.
- Voltmeter , Ammeter , MCB’s , indicating lights
- Push buttons
- Rocker Switches for Dozers
- Incomers, Auto- Manual Switches
- INSTRUMENTATION
Specifications
- Rota Meter : 2 nos (permeate & Reject line )
- Make : Flowstar , Vats
- Digital TDS/ Conductivity Meter 1 no at extra cost
- Make : Vats India
- Pressure Switch : 2 Nos
- Make : Indfoss/Denfoss
- Pressure Gauges : 2 Nos
- Make : Gluck/ Guru
- PLUMBING & FITTING
- Pipelines upvc
- NRV’s pressure relief valves , where needed .
- The system with be on common MS base frame or SS as per Direction of Client.
FINANCIAL OFFER
Product Specification Qty Unit Price Amount Supply and Installation of Complete Reverse Osmosis System Capacity 500 LPH 01 1,25,000.00 1,25,000.00 Packing
Not Reqd
Freight & Insurance
As per actual (Max Rs 1500/)
Erection & Commissioning
Include
Rates are Excluding Tax
TERMS AND CONDITION
The following terms and conditions shall apply to this order. Payment 50 % advance along with purchase order.40 % against Performa invoice before delivery.Bal 10 % after Erection & Commissioning. Validity This offer is valid for acceptance till 60 days from the date of offer. Warranty 12 months from the date of delivery / installation . Consumable Like chemical and filters will be on chargeable basis during warranty period. Prices are excluding taxes Testing / Inspection Any charges for inspection / testing would be on the client' account. Facilities at site The buyer at his cost shall arrange the following facilities at site available. The requisite utilities, manpower and raw materials should be available at the time of installation and commissioning. All other terms and conditions shall be discussed and agreed / finalization mutually at the time of agreement.
EXCLUSIONS
The following are specifically excluded from our scope of work:
- All process inputs, utilities such as tube well for water, power supply and distribution system, inlet –outlet-piping ete.
- Fire Fighting Equipment.
- All civil works including building, shed, foundations, roads, ramps, storage tanks etc
- Warehousing, storage and safe custody of equipment and other plant items received at site.
- Temporary power supply during construction and erection of plant
- Effluent Treatment.
- Any other services / equipment not specifically mentioned.
- Model of the plant.
Our Termination Points :
- Raw Water Pump Suction
- Outlet of permeate water and reject water
- Overflow and drains of respective dosing tank & vessel
- Inlet of all measuring tanks.